The Victor® Multi-Kill® Mouse Trap uses a high-voltage shock to kill mice in seconds. More efficient than traditional single-mouse snap traps, the Multi-Kill® can kill up to ten mice per setting and up to 150 mice per set of four “C” batteries, with a 100% kill rate.
The Victor® Multi-Kill® Mouse Trap is very easy-to-use. Simply bait, place and turn on. When baiting, be sure not to over bait, and don’t get any bait or other material directly on the metal plates as this will falsely trip the system. A green light will flash once to indicate the trap is working properly.
There are two ways to get in to the Victor® Multi-Kill® Mouse Trap, and zero ways out. Mice climb one of two staircases to reach the Shock N' Drop Chamber™ where the bait and metal plates are located. Inside, the patented tunnel design and bevelled columns hold the mouse in place as it steps onto metal plates to reach the bait. This contact completes the circuit and issues a high-voltage shock that kills the mouse in seconds. The chamber rotates automatically to deposit the mouse into the Collection Drawer, and then resets itself for the next mouse.
The light above the power switch will blink green for up to seven days to indicate a kill. A yellow light blinks when the collection drawer is full, and a red light blinks to let you know when to replace the batteries. To dispose of the mice, just slide open the collection drawer and dump the bodies directly into the trash for a safe, clean, no-see, no-touch disposal.
The Multi-Kill Mouse Trap can be used anywhere indoors. It doesn’t use chemicals or poisons, and features a built-in safety switch that automatically deactivates the trap whenever the lid is opened, making it safe to use around children and pets.
Remove battery cover. Unwrap and insert the 4 “C” batteries provided. Replace the battery cover.
Open the top of the Multi-Kill® Electronic Mouse Trap.
Bait the trap using the bait trough provided. The bait trough is located on the back wall of the trap. Apply a small amount of peanut butter or anything high in protein like chocolate, hazelnut spread, etc. Be sure to use a Q-tip, toothpick or another tool to bait so your scent is not transferred onto the trap. Close the lid on the electronic mouse trap.
Place the trap where you have seen signs of rodent activity or along the wall where rodents primarily travel. The trap should be placed lengthwise against the wall with the entrance holes nearest the wall.
Turn on the trap – a green light will blink once showing the trap is working properly.
A blinking green light will indicate a kill. Dispose of the dead rodent, bait, place and reset for continued rodent control.
The Victor Multi-Kill Mouse Trap features a built-in safety switch that automatically deactivates the trap whenever the kill chamber door is opened. The trap has no poisons or chemicals and is safe to use anywhere in the home. The Victor Multi-Kill is extremely economical and can be used for years to ensure effective mouse control.